CIF Series Crushable Incinerable Cartridges

 

The Facet CIF Series high efficiency pleated paper filter cartridges are designed to effectively remove solid contaminants from fuels.

Media with high efficiency throughout the life of the cartridge is available in ratings from .5 to 5 microns. We recommend replacing cartridges when the differential pressure reaches 15 psi (1.03 bar). Effective life above 15 psi (1.03 bar) is minimal.

All cartridges are 6" (152 mm) outside diameter. To simplify maintenance, we offer one piece cartridges in three lengths:

  • single-length of 14½" (370 mm)
  • double-length of 28¾" (730 mm)
  • triple-length of 43¼" (1090 mm).

One triple-length cartridge replaces three single-length.

To use the CIF Series cartridge requires the one time installation of either a single, double or triple length centre tube kit. Each kit contains all necessary hardware and components required to convert any housing fitted for 6" (152 mm) OD x 3½" (89 mm) ID diameter cartridges.

These high efficiency pleated paper filter cartridges designed to effectively remove solid contaminants in applications such as:

  • Gasoline
  • Coolants
  • Kerosene
  • Rolling Oils
  • Diesel
  • Jet Fuel
  •  AV-Gas
  • Industrial Water
  •  Solvents (Stoddard and Ketone Based)

The filtration of potable liquids is not recommended with this series of filter cartridges.

We recommend replacing cartridges when the differential pressure reaches 15 psi. Effective life above 15 psi is minimal.

Features & Benefits
  • Crushable - can reduce your disposal volume approx. 80%
  • No metal components
  • Incinerable
  • Cartridges alignment is executed at top of centre tube
  • Lightweight - contributes to reducing change out time
  • Same performance and efficiency as M Series high efficiency pleated paper filter cartridges

ADD TO ENQUIRY CART  REQUEST A QUOTE 

Recommended products for replacement

    Technical Information

    Flow direction
    Outside to in

    pH Range
    From 5 To 9

    Max. recommended operating temperature
    240°F (115°C)

    Initial differential pressure
    2 psi (.14 kg/cm²) or less

    Design collapse pressure
    75 psi (5.25 kg/cm²)

    Materials
    Constructed with high efficiency pleated paper.
    No metal components—end caps and centre tubes are engineered plastics.
    Gaskets are Buna-N—other materials available by request

    Installation Instructions:

    To Install The CIF Series Centre Tube

    1. Remove existing filter cartridge. NOTE: Leave centre rod in position.
    2. Identify bottom of centre tube. Only the top of center tube will accept top adaptor
    3. Place centre tube assembly with the bottom guide down making sure it is properly aligned on the existing cartridge adaptor.
    4. For kit numbers CIF2 and CIF3, be sure to properly align centring guide over centre rod.
    5. Slide top adaptor over centre rod and secure in centre tube using jam nut (thinner of two nuts). Tighten to 5 foot pounds (6.78 Nm).
      At this point you have successfully installed your permanent centre tube.

    To Install the CIF Series Cartridge

    1. Slide cartridge over centre tube. Install NEW black yoke domed head up. 
    2. Place rubber gasket washer (9) (supplied with filter cartridge) over centre rod.
    3. Place flat steel washer (10) over rubber gasket washer.
    4. Place steel lock washer over flat steel washer and secure 5 foot pounds (6.78 Nm) with hex nut
    Ordering Information
    Item Micron Rating Nominal Length
    in mm
    CIF0.5LX3 0.5 44 5/8 1133
    CIF1 1 14½ 370
    CIF1X2 1 28¾ 730
    CIFLX3 1 44 5/8 1133
    CIF2 2

    14½

    		 370
    CIF2X2 2 28¾ 730
    CIF2LX3 2 44 5/8 1133
    CIF5 5

    14½

    		 370
    CIF5X2 5 28¾ 730
    CIFLX3 5 44 5/8 1133

     

    Resources
    Use your Enquiry Cart to make an enquiry, send your collection to a friend via email, or add your item into your wishlist.
    Submit Enquiry 
    Submit a product Enquiry / Quote to Liquip customer service
    Save as Wishlist 
    Save as Wishlist - handy function for account holders
    Send to a Friend 
    Send you selection of products to a friend via a convenient email link
    Item Description
    Add Item into Enquiry Cart
    CIF0.5LX3 Micro Rating (0.5), Nominal Length (44 5/8in / 1133mm)
    CIF1 Micro Rating (1), Nominal Length (14 1/2in / 370mm)
    CIF1X2 Micro Rating (1), Nominal Length (28 3/4in / 730mm)
    CIF2 Micro Rating (2), Nominal Length (14 1/2in / 370mm)
    CIF2LX3 Micro Rating (2), Nominal Length (44 5/8in / 1133mm)
    CIF2X2 Micro Rating (2), Nominal Length (28 3/4in / 730mm)
    CIF5 Micro Rating (5), Nominal Length (14 1/2in / 370mm)
    CIF5LX3 Micro Rating (5), Nominal Length (44 5/8in / 1133mm)
    CIF5X2 Micro Rating (5), Nominal Length (28 3/4in / 730mm)
    CIFLX3 Micro Rating (1), Nominal Length (44 5/8in / 1133mm)
    View Enquiry Cart

    Item added into a Enquiry Cart

    Use your Enquiry Cart to make an enquiry, save your cart as wishlist or send your collection to a friend via email.
    View Enquiry Cart

    Related Products

      Interested?

      Contact us for a quote or for further information.
      Are you enquiring about multiple products? Consider using our Enquiry Cart